![]() ![]() In and out seems a little fuzzier to me, but even then moving the carriage until the drill tracks on center seems pretty quick and easy. ![]() Angle seems just as easy, dial indicator and some drill rod to dial it parallel with the ways. So, any first-hand experience floating around out there? How easy is alignment to start drilling? Vertical seems dead simple, set that once and never change it. Id like a way to make drilling deeper holes slightly more tolerable, tailstock only has 1.5 inches of travel and sweet jimney christmas that crank it a bloody pain after a bit. QCTP Tool Holders 3119 Compatible with 2 Morse Taper Shanks Hardened and Ground Compatible with 0XA, or Series 000, Tool Post Number 2 Morse taper. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |